Publicité
Les langues disponibles
Les langues disponibles
2. The blower doesn't
work after pressing the
start bottom.
If after stabilization, it
doesn't work, there must
be wrong
3. No feeding after 20 seconds of starting.
There are three stages for the feeding process.
One is during the several minutes, feeding is constantly. "Feeding" is showing on the LCD
display
Two is the following couple minutes, the feeding light is off.: "Light" showing on the Display
The last stage is that feeding Every several seconds all the time after previous stages.
A. For the first stage
(during first several
minutes)
It is normal.
It will start automatically when
the temperature is
above 30 degrees on the
venting pipe.
No power in stove or in the
control panel.
Or Unplugged on the mother
board
The low temperature sensor is
broken
Feed unit is blocked.
There is the problem
about the connection
between motor and auger
No fuel in the hopper.
78
Please wait
Check the power and wires.
Plug it
Replace it
Check the auger is blocked or not.
Check the fasten screw between
auger and motor loose or not.
Or the auger might jump
out
Fill the fuel into the hopper.
Publicité
