Delba CAPRI Mode D'emploi page 55

Turning the Equipment On and Off
To turn the equipment on and off, press the button
(until you hear a beep), if you are turning on the equipment on the remote
When you hear the beep, stop pressing the button and the stove will start the
As soon as the equipment is turned on, the following message will appear on
the display:
This operation lasts between 2 and 3 minutes and is intended to carry out a
previous automatic cleaning of the existing piping inside the equipment and
to preheat the ignition element.
At the end of the cleaning time, the stove will move on to the second phase:
During ignition, the motor that transports the pellets from the tank to the
burner will work alternately (places pellets and stops) until the pellets that fall
into the burner ignite.
From the moment of ignition, the auger motor will continue with the same
operation until the chamber heats up and reaches 60 Cº.
control, just press the button once.
process by itself.
The start-up process consists of 3 phases:
-Cleaning
-Ignition
-Stabilization
55
for 4 seconds