Publicité
Les langues disponibles
Les langues disponibles
Menu
To enter the menu, press the key
beep).
The first parameter that will appear is the adjustment of the fans for the
four power levels.
In this parameter, you can configure the speeds of the gas extractor (S) and
The extractor speed will depend on the type of installation, brand of pellets and
the burning of the machine, so it must be adjusted while the equipment is in
operation.
If the glass turns black after a few minutes of the machine being on or starts to
accumulate too many pellets in the burner, it is a sign that the extractor needs
more speed, so you have to increase the value of S which by default comes to
0 by default.
If the flame is very strong, the pellets are constantly jumping from the burner
and the flame starts to want to go out, this is a sign that the extractor is too
strong and needs to be reduced.
Attention, at power 4 (minimum) the flame is very small, it barely comes out of
the cup.
To change to parameter F, just press the key
This parameter is used to increase or reduce the speed at which the hot air is
projected to the room where the equipment is located.
To confirm and move to the next parameter, just press the key
After passing P4, P5 will appear, which is related to the speed of the
extractor when the machine is cleaning and then P6 will appear, which is
related to the speed of the extractor in the ignition process.
for 4 seconds (until you hear the
.
62
the hot air fan (F).
.
Publicité
