Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION / CONNECTION
This range hood should be mounted directly to the support frame mounting, with the support frame flue
secured to the ceiling joist or framework.
Ductwork needs to be installed at the top of the unit where the motors exhaust.
Duct runs should be as short as possible.
Avoid the use of elbows.
Use duct tape on all joints.
Do not use a duct smaller than the exhaust on the hood.
LOCATION PREPARATION
The installation in this manual is intended for qualified installers, service technicians or persons with a
similar qualified background. DO NOT attempt to install this appliance yourself. Injury could result from
installing the unit due to lack of appropriate electrical and technical background.
All electrical wiring must be properly installed, insulated and grounded. Excessive accumulated grease
in old duct work should be cleaned out or duct work should be replaced if necessary, to avoid the
possibility of a grease fire. Check all joints on duct work to ensure proper connection, and all joints
should be properly taped.
Note 1: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces
of the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
MOUNTING HEIGHTS & CLEARANCE
Publicité
