Publicité
Les langues disponibles
Les langues disponibles
INSTALL WARMING SHELF TO THE HOOD
• Install 2x M4x8mm self-tapping screws into "D" holes at the
bottom of the hood flange, leaving a gap of 1/8".
• Remove shelf packaging and protective film (if any).
• Attach the warming shelf to the bottom of hood by inserting
the top of the self-tapping screws into the keyhole slots on
the top of the shelf. Slide the shelf towards the left to lock it
into place.
• Tighten 2x M4x10mm screws & washers through the
bottom of the shelf into the hood flange in the "E"
position
INSTALL HOOD ONTO WALL
SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR CABINET
Install outlet adapter onto top of hood
IMPORTANT: Check that the damper moves freely
• Place the outlet adapter (1x) over the hood exhaust
and secure with 2x M4x12mm self-tapping screws
• Use duct tape to seal the connection. Check to make
sure the damper moves freely.
Hang hood on mounting bracket
Lift the hood and hold it close to the mounting bracket. Line up mounting
holes in "B" position.
Make sure the screw head on the bracket is engaging into the keyhole
slots on the back of the hood.
Slide down the hood to make it hang correctly on the bracket.
Tighten the screws in the "B" position.
Make sure the hood is leveled and centered. 8 holes in the "C" position
must line up with bracket holes properly.
Install 8xM4x8mm self-tapping screws through the back of the hood in
the "C" positions and tighten to the mounting bracket.
Publicité
