Publicité
Les langues disponibles
Les langues disponibles
Hood Cleaning
The saturation of greasy residue in the blower and filters may cause increased inflammability. Keep
unit clean and free of grease and residue build-up at all times to prevent possible fires.
Filters must be cleaned periodically and free from accumulation of cooking residue (see cleaning
instructions inside). Old and worn filters must be replaced immediately. Do not operate blowers
when filters are removed. Never disassemble parts for cleaning without following proper
instructions. It is recommended that disassembly be performed by qualified personnel only. Call our
service centre for removal instructions.
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its
fine appearance.
Cleaning tips:
* Hot water with soap or detergent is all that is usually needed.
* Rinse with clean water. Wipe dry with a clean, soft cloth to avoid water marks.
* For persistent discoloration or deposits, use a non-abrasive household cleanser or stainless steel
polishing powder with a small amount of water and a soft cloth.
* For stubborn stains use a plastic scouring pad or soft bristle brush together with cleanser and water.
Rub lightly in the direction of polishing lines or the "grain" of the stainless finish. Avoid using too much
pressure as this may damage the surface.
* Do not allow deposits to sit for long periods of time.
* Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface
causing rust.
* Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these compounds contain chemicals that may be
harmful. Rinse with water after exposure and wipe dry with a clean cloth.
* Painted surfaces should be cleaned with warm water and mild detergent only.
LIGHT
WARNING
Please ensure that lights have been switched off for some time and the power source has
been disconnected before replacing any bulbs. Please be aware that the light will retain heat
for a short period of time after being switched off.
Holes for installing LED strip light
Heat light hole
Publicité
