Télécharger Imprimer la page

Forno FRHWM5029-30 Manuel D'instructions page 14

Masquer les pouces Voir aussi pour FRHWM5029-30:

Publicité

Les langues disponibles

Les langues disponibles

Mount Hood onto Soffit or Cabinet
Note: If mounting to the underside of a cabinet
with a recessed bottom, install shims to fill the
gap
• Drive mounting screws into the studs until they
protrude by 1/4". The 1/4" gap will provide
clearance to engage the keyhole slots in the top
of the hood.
• Lift hood to installation position.
• Lift hood onto mounting screws. Slide back
against the rear wall.
• Tighten mounting screws.
IMPORTANT: For additional support and to minimize vibration during operation, the hood must be
secured to the back wall. Use wall anchors to fasten bottom back of hood to the wall.
CONNECT DUCTWORK
• Install ductwork, making connections in direction of airflow as illustrated
• Wrap all duct joints with duct tape for an airtight seal.
• Use duct tape to seal the flange connection. Reach inside the hood and push the damper up to be
sure it moves freely.
IMPORTANT: Avoid over-tightening the duct on the damper. Excessive tightness can prevent the
damper from opening properly and may cause the motors to malfunction. It is essential to ensure that
the damper moves freely before completing the installation. Please take the time to verify its unrestricted
movement for optimal functionality.
Duct tape
over seam
and screw
Duct tape
over transition
Engage top
1/4" gap
keyhole slots
Push back
to wall
Airflow
Soffit
Add shims
if bottom is
recessed.
Back wall

Publicité

loading