Verify Anti-Tip Bracket Location; Level Range - Whirlpool GS440LEMT5 Instructions Pour L'installation

5. To mount anti-tip bracket to wood floor, drill two ¹⁄₈" (3.2 mm)
holes at the positions marked on the bracket template.
Remove template from floor.
To mount anti-tip bracket to concrete or ceramic floor, use a
³⁄₁₆" (4.8 mm) masonry drill bit to drill 2 holes at the positions
marked on the bracket template. Remove template from floor.
6. Tap plastic anchors into holes with a hammer.
7. Align anti-tip bracket holes with holes in floor. Fasten anti-tip
bracket with screws provided.
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
8. Move range close to opening. Remove shipping base,
cardboard or hardboard from under range.
9. Connect power supply cord as described in the "Electrical
Connection" section.
10. Move range into final position making sure rear leveling leg
slides into anti-tip bracket.
11. Continue installing your range using the following the
installation instructions.
8

Verify Anti-Tip Bracket Location

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Move range close to cabinet opening.
2. Remove cardboard or hardboard from under range. Gently
move range into its final position.
3. Pull drawer open to first stop position. Lift front of drawer to
clear white wheels in drawer guides. Remove drawer and set it
aside on a protected surface. See the Use and Care Guide for
the model drawer removal.
4. Making sure the anti-tip bracket is installed:
Look for the anti-tip bracket securely attached to floor.
Slide range back so rear range foot is under anti-tip
bracket.
5. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.

Level Range

Place rack in oven. Place level on rack, first side to side; then front
to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket. Use ³⁄₈" drive ratchet and
channel lock pliers to adjust leveling legs up or down until range is
level. Push range back into position. Check that rear leveling leg is
engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory baking performance.