Publicité
Les langues disponibles
Les langues disponibles
1.
Position a container under the tank to collect fuel;
2.
(ACCESS J 36-50 and ACCESS J 60-75): Close the fuel valve [Fig. 30];
3.
Open the tank cap [Fig. 06];
4.
Untighten the carburetor bleed screw [Fig. 36];
5.
(ACCESS J 36-50 and ACCESS J 60-75): Open the fuel valve [Fig. 15];
6.
Let the fuel flow into the container and empty the tank;
7.
Tighten the carburetor bleed screw and close the tank cap.
11. TROUBLE SHOOTING
If, following several attemps, the engine of the pump still does not start, please refer to following table.
Then, if the pump cannot start, please contact the WORMS Entreprises dealer or the nearest After-
Sales Service to get information and to be instructed with measures to take.
THE ENGINE CANNOT START:
Make sure position of the CHOKE LEVER is
correct
Make sure the fuel cock is opened
Check petrol level.
Oil level too low (oil sensor security has
triggered).
Make sure the position of the engine switch is
correct.
Make sure the spark plug is not dirty.
Make sure the spark plug cap is correctly fitted
THE ENGINE SUDDENLY STOPS:
Out of fuel
Oil level too low (oil sensor security has
triggered).
LACK OF POWER FOR THE ENGINE:
Air filter clogged
46
Put the CHOKE LEVER to the START
(CLOSED) position.
Open the fuel cock if it is closed.
Fill up the tank in case it is empty. Do not overfill it
Check oil level and top up.
Put the ON / OFF switch to position ON
(START).
Remove the spark plug and clean the electrode.
Fit the spark plug cap in case it is removed.
Fill with fuel.
Check oil level and top up.
Replace the air filter
Publicité
