Struers RotoForce-4 Manuel D'instructions page 18

Location of Main Switch
General Use of Keys
Acoustic Signals
The Handle
Changing to Another Lupo Unit
(Accessory)
12
RotoForce-4
Instruction Manual
The main switch is located on the back of RotoForce-4.
m
MENU , and SELECT
machine has been stopped.
L
SELECT can only be activated when MENU
Short Beep: When pressing a key, a short beep indicates
that the command has been accepted
Long Beep: a long beep indicates that the key cannot be
activated at the moment.
The handle of RotoForce-4 is used to raise and lower the
specimen mover and to lock it in working position. The
handle has three positions which are indicated with dots.
Handle in Top Position: When the handle is placed at one
dot, RotoForce-4 is moved to its upper position. This position
is used to insert specimen holders/specimen mover plates,
and to allow positioning of RotoForce-4 correctly over the
preparation disc.
Handle in Adjusting Position: When the handle is moved
down to two dots, RotoForce-4 is lowered into its working
position. RotoForce-4 can now be adjusted horizontally in
relation to the turntable.
Handle in Working Position: When the handle is moved
all the way down to three dots, RotoForce-4 is locked into
working position.
Be careful not to move the handle too fast from position
as RotoForce-4 may not have reached the working position.
(A message will blink on the display: LOCKING TOO FAST)
Set the mode switch on Lupo to STOP
Remove the current Lupo. Remove the silicon tube from the
nipple underneath Lupo.
Place the other Lupo (accessory) with an alternative lubricant
in the connector on the supporting arm. Connect the silicone
tube to the nipple.
L
can only be activated when the
o
position.
m
is selected.
to ,