Elica PRF0185060 Prescriptions De Montage Et Mode D'emploi page 22

residue and ensure maximum hygiene levels.
● Cleaning the metal grille:
The grille must be washed by hand with hot water and
neutral detergent, then dried thoroughly to prevent
oxidation.
EXTRACTOR FAN MAINTENANCE
● Cleaning the extractor fan :
For cleaning, use
ONLY
liquid detergents.
DO NOT USE CLEANING UTENSILS OR TOOLS!
Avoid the use of products containing abrasives.
USE ALCOHOL!
● Grease filter maintenance:
Traps grease particles generated by cooking.
Must be cleaned once a month (or when indicated by the
filter saturation indication system), with non-aggressive
5. ASSISTANCE
TROUBLESHOOTING TABLE
Informative code
For all other error sig-
nals
CUSTOMER SERVICE
Before contacting Customer Service
1. Check that the problem cannot be solved by consulting the points in "Troubleshooting".
2. Switch the device off and on again to see if the problem resolves itself.
If the fault persists after the above checks, contact the nearest Customer Service centre.
a cloth moistened with neutral
DO NOT
Description
The command zone switches off
due to an excessively high tem-
perature
Container unsuitable
Communication problems
between the user interface and
induction module
Call customer service and report the error code
detergents, either by hand or in the dishwasher at low
temperatures and in a short cycle. When cleaned in the
dishwasher, the metal grease filter may discolour, but its
filtering characteristics remain unchanged.
● Ceramic activated carbon filter maintenance
(For Recirculating Version only):
Traps unpleasant odours generated by cooking. The
product comes with a set of odour filters.
The saturation of the odour filters can occur after
somewhat prolonged use depending on the type of cooking
and how regularly the grease filter is cleaned. The odour
filters can be thermally regenerated every 2/3 months in an
oven pre-heated to 200°C for 45 minutes. The correct
regeneration of the filter ensures that it can constantly filter
efficiently for 5 years.
Please note! Do not place the filters on the floor of the
oven but rather in a tray, positioned at an intermediate
height.
Possible causes
The temperature inside the elec-
tronic parts is too high
Loss of magnetic properties
No power supply to the module;
the power cable has not been
connected correctly or it is faulty
22
Solution
Wait for the hob to cool be-
fore reusing it
Remove the pot
Disconnect the hob from the
electrical network and check
the connection