Publicité
Les langues disponibles
Les langues disponibles
10.2 INNER CLEANING
Unplug from the mains before cleaning.
By tank cleaning, proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves
2. Unplug the unit
3. Leave the doors open and begin the operation of tank washing when the tank temperature is the same as
the ambient temperature.
4. Clean and dry the interior of the tank with a soft cloth, using neutral soap.
5. Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
ATTENTION!
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
11
TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate
pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
• Press the (C) key in order to see on display the temperature set point.
• Press the (A) key or the (B) key in order to increment or decrement the temperature set point
• Press the (C) key in order to store the new temperature set point.
C
A
B
Electronic control
Internal motor fan microswitch
(with door open: internal motor fan
disconnetted)
E
D
A)
Button to increase temperature
B)
Button to decrease temperature
C)
Button to show set temperature
D)
Automatic defrosting button
(press for defrosting start)
E)
Light switch
-33-
Publicité
