IARP GLEE 45wv2 Lite Instructions Pour L'utilisateur page 30

7.8 PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be
left to stand for at least three hours before being started to allow the lubricating oil to settle in
the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT
IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying
with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
Earthing is necessary and compulsory by law. Absolutely never use reduction units, patch cords,
adapters or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped
on, away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer
or by instruction it change of it.
8. PROLONGED SWITCH OFF
When the unit is not used for a long time, please take note of the following procedures:
• Unplug the unit.
• Clean and dry the tank well.
• Leave the glass door open to avoid possible formation of bad odours.
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
-31-