AYA ATI3/3 Manuel D'utilisation page 70

4. The wall and induced heating zone above the table surface
shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive
must be resistant to heat.
6. A steam cleaner is not to be used.
Connecting the hob to the mains power supply
This hob must be connected to the mains power supply
only by a suitably qualified person Before connecting
the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn
by the hob.
2. The voltage corresponds to the value given in the rating
plate.
3. The power supply cable sections can withstand the load
specified on the rating plate.
To connect the hob to the mains power supply, do not use
adapters, reducers, or branching devices, as they can cause
overheating and fire.
Check with an electrician whether the domestic wiring
system is suitable without alterations.
Any alterations must only be made by a qualified
electrician.
69