Publicité
Les langues disponibles
Les langues disponibles
Heating zones of the
same side ( Such as
the first and the
second zone ) would
display "
" .
Fan motor sounds
abnormal.
The above are the judgment and inspection of common
failures.
Please do not disassemble the unit by yourself to avoid any
dangers and damages to the induction hob.
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the
drawing.
For the purpose of installation and use, a minimum of 5 cm
space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm.
Please select heat-resistant and insulated work surface
material (Wood and similar fibrous or hygroscopic material
shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger
deformation caused by the heat radiation from the hotplate.
As shown below:
Note: The safety distance between the sides of the hob
and the inner surfaces of the worktop should be at least
3mm.
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
64
Publicité
