Publicité
Les langues disponibles
Les langues disponibles
Description of the appliance
The colour of the box changes when it is filled with water: as the walls absorb water, they become
darker. Depending on the hardness of your tap water, some white limescale stains may appear on
the material. To avoid this, you may use descaled or distilled water. The white stains can be washed
off.
After placing the HumidityBox in the correct zone, it will take approximately 9 hours to increase the
humidity back from 40% to 50%. After 9 hours, humidity will continue to slowly increase.
On average, the HumidityBox should be refilled every 30 days. The appliance will sound an alarm
when humidity gets too low (below 40%).
You can also buy additional HumidityBoxes when needed.
Please do not put the HumidityBox in the dishwasher, as this type of material is not dishwasher safe.
Because of the relatively thin walls, the box is fragile and should be handled carefully. Occasionally,
shower the inside of the box with tap water.
INFORMATION!
For more informations refer to the local Atag dealer or to the Atag website of your country.
28
Fill the box with 0.5 litre of tap water and place
it in the relevant zone. There are no preferrable
positions, as long as it is placed in the correct
zone.
HumidityBox is made of clay, a natural material
with the right characteristics to first absorb
water and then allow it to evaporate to increase
humidity.
The walls and bottom of the clay box are
glazed to prevent water leakage. Water is
absorbed by all walls, but will only evaporate
through the unglazed top surface.
The HumidityBox is made in an artisan
workshop with fine craftmanship. As a result,
minor irregularities in material or shape may
occur. They, however, do not have any effect
on functionality.
Publicité
