MINN KOTA TALON Instructions D'installation page 36

ONE-BOAT NETWORK APP
TALON APP BUTTONS
Auto Up
Tap to retract the anchor.
Auto Down
Double tap to deploy the anchor.
Pause
Tap to interrupt the current action. The Talon(s) will remain at the current depth until another command is sent. The action
for both deploying and retracting the anchor can be paused. The Pause button will appear in place of the Auto Up or Auto
Down buttons during deploying or retracting and disappear when the unit pauses.
Depth Indication
Increments the depth that the Talon is deployed or retracted. The spacing of the increments will vary depending on if an 8',
10', 12' or 15' Talon is being controlled.
Standard Mode
In Standard Mode, the Auto Deploy feature will
operate with maximum down-force with a complete
Auto-Drive cycle of three hits spaced at three
seconds apart.
Rough Water Mode
In Rough Water Mode, the Auto Deploy feature will
operate with maximum down-force with three
Auto-Drive cycles of three hits each, spaced three seconds apart. The three Auto-Drive cycles will be spaced at
10-second intervals.
Soft Bottom Mode
In Soft Bottom Mode, the Auto Deploy feature will operate at reduced power with a single hit, preventing the Talon from
over-anchoring in water with muddy or soft, sandy bottoms.
Talon Selection - Both
Indicates both the left and right Talons are selected
and will be controlled while operating. Tap to toggle
between left, right, and both Talons.
Talon Selection - Left
Indicates the left Talon is selected and will be controlled while operating. Tap to toggle between left, right, and both Talons.
Talon Selection - Right
Indicates the right Talon is selected and will be controlled while operating. Tap to toggle between left, right, and
both Talons.
36 | minnkota.johnsonoutdoors.com
NOTICE: If power is cycled to the Talon, the Talon will
"remember" if it was last in "Standard Mode" or "Soft
Bottom Mode" and will return to the previously known
mode. However, if set to "Rough Water Mode" and power
is cycled, it will default to "Standard Mode" to prevent the
Talon from unnecessarily over-anchoring.
NOTICE: The Talon Selection options are only visible when
the Talon is set up to control two Talons.
©2024 Johnson Outdoors Marine Electronics, Inc.