MINN KOTA TALON Instructions D'installation page 21

VERIFYING INSTALLATION
Verifying Installation
Once installation is complete, use the following procedure to verify installation and confirm your Talon is ready to use.
1
a. For this test your Talon must be able to deploy
and make contact with the ground without hitting
any obstructions. Carefully inspect the area around
the Talon for any obstructions that may interfere
with deployment.
b. If using a battery selector, or power disconnect switch,
turn the selector switch to the "on" position. On the
Indicator Panel of the Talon are three buttons needed
for this verification, the Up
button and the Mode
button until the Mode LED is unlit.
2
c. Stand clear of the Talon and push the Down
button. The Talon spike will begin to deploy. The
Depth Indication LEDs on the Indicator Panel will
track the progress of the Talon as the Spike deploys.
d. When the Spike comes in contact with the ground,
the unit will automatically shut off. After the initial
shut off, you will hear two (2) additional deploy cycles
(or clicks), each 3-seconds apart from the initial
ground contact.
e. If the Talon functions as described above, press the
Up button. The Talon will fully retract. If the Talon
does not function as described, double check all
wiring connections and verify proper polarity to white
and black power leads and retest.
NOTICE: To perform the same test using the remote
instead of the buttons on the Indicator Panel, use
the Anchor Mode
the Down
anchor on the remote, the Down
double pressed.
©2024 Johnson Outdoors Marine Electronics, Inc.
button, the Down
button. Press the Mode
button, the Up button, and
button on the remote. To deploy the
button must be
Indicator Panel
Up Button
Mode Button
Down Button
Talon
Trailered
Boat
Deployed
Spike
Ground
Talon Mode LED
Remote
Mode
Button
Auto Up/Down
Buttons
Indicator Panel
Up
Button
Mode
Button
Down Button
minnkota.johnsonoutdoors.com | 21