MINN KOTA TALON Instructions D'installation page 11

5
i. Next, note the position of the nuts, washers and
screws holding the Mounting Strap in place. The Hex
Head Cap Screws pass from the inside to the outside
of the bracket. They first pass through the Mounting
Strap, then a Guard Washer, then the Mounting
Bracket. On the outside of the bracket, the screw first
holds a Flat Washer and then a Lock Washer before
being secured with a Nylock Nut.
j. After the appropriate Nylock Nut has been loosened,
locate the Nylock Nut opposite of the loosened one on
the Mounting Strap and remove it.
k. Adjust the Mounting Straps so that they are as
perpendicular to the waterline as possible.
CAUTION
Do not use the Mounting Bracket or Talon as a step to enter
the boat. The bracket will be slippery when wet and is not
designed to support people. Using this product as a step
may result in injury.
6
l. Once perpendicular, replace the hardware that
was removed by selecting one of the five Angular
Adjustment Holes that will support the Mounting Strap
at the most perpendicular position.
m. To replace the bolts, pass them from the inside to the
outside, through the Mounting Strap, then the Guard
Washer, then the Mounting Bracket, a Flat Washer and
Lock Washer. Then loosely secure with a Nylock Nut.
The nuts will be fully secured later in the installation.
NOTICE: To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
The hardware holding the Mounting Straps in place
has a pre-applied anti-seize.
©2024 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE TALON
5i
Nylock
Nut
Lock
Washer
Mounting
Bracket
Flat Washer
Washer
5k
Mounting Mounting
Mounting Mounting
Straps Straps
Bracket Bracket
Water Water
Angular Angular
Line Line
Adjustment Adjustment
Holes Holes
Perpendicular Perpendicular
Placement Placement
Right-side-up Right-side-up
Nylock
Nut
Lock
Washer
Flat Washer Mounting
Bracket
Guard
Washer
Hex Head
Cap Screw
Mounting
Strap
Mounting
Strap
Guard
Washer
Guard
Hex Head
Cap Screw
5k
Angular Angular
Adjustment Adjustment
Holes Holes
Mounting Mounting
Bracket Bracket
Perpendicular Perpendicular
Water Water
Placement Placement
Line Line
Up-side-down Up-side-down
Mounting
Strap
Hex Head
Guard
Washer
Mounting
Bracket
Lock
Washer
Flat Washer
minnkota.johnsonoutdoors.com | 11
Mounting Mounting
Bracket Bracket
Nylock
Nut
Mounting Mounting
Straps Straps
Cap
Screw
Nylock
Nut