PAIRING THE ONE-BOAT NETWORK FOR TALON
Pairing a Remote with a Single Talon
Every Talon comes direct from the factory with a remote already paired to the Talon. However, any Talon can be paired with up to four
remotes per Talon.
1
a.
Retract the anchor on the Talon by pressing the
Up
button on the Indicator Panel.
b.
Once the Talon is fully retracted, press and hold
the Up
button and the Down
the Remote at the same time until the Talon
Selection LEDs on the Remote begin to scroll.
Then release them.
c.
Immediately press and hold the Up
the Down
Panel. The Depth Indication LEDs will begin to flash
blue. Once the LEDs are flashing release the buttons
on the Indicator Panel. The Talon and Remote will
go into Pairing Mode for 20 seconds. If a signal with
three fast beeps occurs, the Talon and Remote have
successfully paired. If 20 seconds pass while in Pairing
Mode and they do not successfully pair, a chirp will
sound signaling that the Pairing has timed out.
d.
If the Pair is unsuccessful, repeat the process.
Pairing a Device with a Single Talon
Pair a Talon Shallow Water Anchor that is Bluetooth enabled with
a single device, and use the One-Boat Network app to control the
Talon. Before pairing the device with the Talon, download the
One-Boat Network app and set up an account. Confirm that the
OBN app has been downloaded successfully by opening the app
on the device. Find the OBN app setup in the One-Boat Network Owner's Manual online at humminbird.johnsonoutdoors.com. Once
confirmed, close the app on the device to begin the pairing process.
©2024 Johnson Outdoors Marine Electronics, Inc.
button on
button and
button simultaneously on the Indicator
1a
Up Button
Down Button
Talon Remote
NOTICE:
A device will only be able to connect to and pair
with a Talon if the device Bluetooth is enabled. A device will
only be able to pair with a Talon that is Bluetooth enabled.
ONE-BOAT NETWORK
Indicator
Panel
Talon Selection LEDs
Auto Up/Down
Buttons & Pairing
Button
minnkota.johnsonoutdoors.com | 25