MINN KOTA TALON Instructions D'installation page 12

INSTALLING THE TALON
7
ITEM(S) NEEDED
NOTICE: We recommend a second person to help
with this step of the installation.
n. Next the Talon Assembly should be installed on the
Mounting Bracket. Take the Talon Assembly (Item #B)
and notice that there is an Assembly Track located on
both sides of the Talon.
o. When the Talon is properly oriented as it would be
installed, there is a single Vertical Stop Bolt located
on the Starboard side of the Talon along the Assembly
Track. The Vertical Stop Bolt is used as a reference
point or guideline to stop the Talon and position the
Mounting Straps in the Assembly Track. Ensure that
the Vertical Stop Bolt is secured in the approximate
final position.
p. Carefully lift the Talon Assembly into the Mounting
Bracket and align the Mounting Straps with the
Assembly Track. Slide the Guard Washers to the inside
wall of the Mounting Bracket, so that they sit between
it and the Talon Assembly. Slide the Talon Assembly
down the Assembly Tracks until it comes in contact
with the Vertical Stop Bolt.
12 | minnkota.johnsonoutdoors.com
#B x 1
Talon
7n
Assembly
Assembly
Track
Assembly
Track
Mounting
Straps
7p
Talon
Assembly
Mounting
Strap
Assembly
Track
Mounting
Bracket
7o
Vertical Vertical
Stop Bolt Stop Bolt
Talon Talon
Assembly Assembly
Port Port Starboard Starboard
7p
Talon
Assembly
Vertical
Stop Bolt
Mounting
Bracket
Assembly
Track
©2024 Johnson Outdoors Marine Electronics, Inc.