Publicité
Les langues disponibles
Les langues disponibles
Key
Processor
Pusher
1
Feed tube
2
Lid
3
Bowl
4
Detachable drive shaft
5
Power unit
6
Speed/pulse control
7
Safety interlocks
8
Cord storage (at back)
9
Attachments
Not all of the attachments listed below may be
included with your food processor. Attachments
are dependent upon the model variant. Visit
www.kenwoodworld.com for information on how
to buy an attachment not included in pack.
10 Plastic Blender
a
Blade assembly
b
Sealing ring
c
Goblet
d
Filler cap
e
Lid
A Standard Attachments
Knife blade
11
Dough tool
12
Emulsifying disc
13
Slicing/grating disc
14
Slicing/grating disc (if supplied)
15
B Optional Attachments
Citrus juicer (if supplied)
16
Plastic mini chopper/mill (if supplied)
17
Grinding mill (if supplied)
18
To Use Your Food Processor
Illustrations
–
1
Fit the detachable drive shaft onto the power
unit.
2
Then fit the bowl by aligning the
bowl with the
on the power unit, turn
clockwise until it locks
3
Fit an attachment over the bowl drive shaft.
Always fit the bowl and attachment onto the
processor before adding ingredients.
4
Fit the lid - ensuring the top of the drive
shaft/tool locates into the centre of the lid.
Do not use the lid to operate the processor,
always use the on/off speed control.
5
Plug in, switch on and select a speed. (Refer
to the recommended usage chart).
(if supplied)
on the
.
The processor will not operate if the bowl
or lid are not fitted correctly into the
interlock. Check that the feed tube and
bowl handle are situated to the right front
hand corner.
Use the pulse (P) for short bursts. The pulse
will operate for as long as the control is held
in position.
6
Reverse the above procedure to remove the
lid, attachments and bowl.
Always switch off and unplug before
removing the lid.
Important
Your processor is not suitable for crushing
or grinding coffee beans, or converting
granulated sugar to caster sugar.
When adding almond essence or flavouring
to mixtures avoid contact with the plastic as
this may result in permanent marking.
Using The Attachments
Refer to recommended usage chart
for each attachment.
Plastic Blender
10
To Use Your Blender
Illustrations
1
Fit the sealing ring into the blade
assembly - ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal is damaged or
incorrectly fitted.
2
Hold the underside of the blade assembly
and insert the blades into the goblet - turn
anti-clockwise until it is secure. Refer to
the graphics on the underside of the blade
assembly as follows:
- Unlocked position
- Locked position
3
Put your ingredients into the goblet.
4
Fit the lid onto the goblet and turn clockwise
until it clicks. Fit the filler cap.
5
Place the blender onto the power unit, align
the
on the blender with the
power unit and turn clockwise to lock
The appliance will not operate if the blender
is incorrectly fitted to the interlock.
Hints and Tips
When making mayonnaise, put all the
ingredients, except the oil, into the blender.
Remove the filler cap. Then, with the
appliance running, add the oil slowly through
the hole in the lid.
5
(if supplied)
–
on the
.
Publicité
