Kenwood FDP300WH Manuel D'instructions page 7

switch off;
wait until the attachment/blades have completely stopped;
be careful not to unscrew the blender goblet or mini
chopper/mill jar from the blade assembly.
Do not use the lid to operate the processor, always use the
on/off speed control.
This appliance will be damaged and may cause injury if the
interlock mechanism is subjected to excessive force.
Never use an unauthorised attachment.
Never use a damaged appliance. Get it checked or repaired:
see 'Service and customer care'.
Never let the power unit, cord or plug get wet.
Do not let excess cord hang over the edge of a table or
worktop or touch hot surfaces.
Children should be supervised to ensure that they do not play
with the appliance.
This appliance shall not be used by children. Keep the
appliance and its cord out of reach of children.
Appliances can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and if they
understand the hazards involved.
Only use the appliance for its intended domestic use.
Kenwood will not accept any liability if the appliance is subject
to improper use, or failure to comply with these instructions.
Misuse of your processor, blender or mill can result in injury.
The maximum rating is based on the mini chopper/mill
attachment that draws the greatest load. Other attachments
may draw less power.
Blender
DO NOT process hot ingredients.
SCALD RISK: Hot ingredients must be allowed to cool to
room temperature before placing in the goblet or before
blending.
Always take care when handling the blade assembly and avoid
touching the cutting edge of the blades when cleaning.
Only operate the blender with the lid in place.
Only use the goblet with the blade assembly supplied.
Never run the blender empty.
Smoothie recipes - never blend frozen ingredients that have
formed a solid mass during freezing, break it up before adding
to the goblet.
Mill Attachments
Never fit the blade assembly to the power unit without the jar/
lid fitted.
Never unscrew the jar/lid while the mill is fitted to your
appliance.
3