Kenwood FDP300WH Manuel D'instructions page 11

Mini Chopper/Mill
17
a
Jar
b
Sealing ring
c
Blade assembly
1 Put the ingredients into the jar.
2 Fit the sealing ring into the blade assembly.
3 Turn the blade assembly upside down. Lower
it into the jar, blades down.
4 Screw the blade assembly onto the jar until
finger tight. Refer to the graphics on the
underside of the blade assembly as follows:
- Unlocked position
- Locked position
5 Place the mill onto the power unit and turn
clockwise to lock in position.
6 Select Maximum speed or use the pulse (P).
Hints and Tips
Baby food/purée - allow cooked food to
cool down to room temperature before
processing in the mill.
For best results the main bowl is
recommended when chopping herbs.
Grinding Mill
18
a
Mill lid
b
Grinding mill blade assembly
1 Place your ingredients into the blade
assembly.
2 Fit the lid and turn clockwise to lock.
3 Place the mill onto the power unit and turn
clockwise to lock.
4 Select maximum speed or use the pulse (P).
Hints and Tips
For optimum performance when processing
spices do not process more than 50g at a
time.
Whole spices retain their flavour for a much
longer time than ground spices so it is best
to grind a small quantity fresh at a time to
retain the flavour.
To release the maximum flavour and
essential oils whole spices are best roasted
prior to milling.
Do not process dried turmeric root in the mill
as it is too hard and may damage the blades.
Cut ginger and coconut into small pieces
before processing.
For best results the main bowl is
recommended when chopping herbs.
(if supplied)
(if supplied)
Care and Cleaning
Always switch off and unplug before cleaning.
Handle the blade and cutting discs with care
- they are extremely sharp.
Some foods may discolour the plastic. This is
perfectly normal and will not harm the plastic
or affect the flavour of your food. Rub with a
cloth dipped in vegetable oil to remove the
discolouration.
Power Unit
Wipe with a damp cloth, then dry. Ensure that
the interlock area
Do not immerse the power unit in water.
Store excess cord in the storage area at the
back of the power unit
Cleaning Instructions - Refer
to the relevant illustration
Service and Customer Care
If you experience any problems with the
operation of your appliance, before requesting
assistance refer to the 'Troubleshooting
Guide' section in the manual or visit
www.kenwoodworld.com.
Please note that your product is covered
by a warranty, which complies with all legal
provisions concerning any existing warranty
and consumer rights in the country where the
product was purchased.
If your Kenwood product malfunctions or you
find any defects, please send it or bring it to
an authorised KENWOOD Service Centre.
To find up to date details of your nearest
authorised KENWOOD Service centre visit
www.kenwoodworld.com or the website
specific to your Country.
Designed and engineered by Kenwood in the
UK.
Made in China.
IMPORTANT INFORMATION FOR CORRECT
DISPOSAL OF THE PRODUCT IN ACCORDANCE
WITH THE EUROPEAN DIRECTIVE ON WASTE
ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE)
At the end of its working life, the product must
not be disposed of as urban waste. It must be
taken to a special local authority differentiated
waste collection centre or to a dealer providing
this service.
7
is clear of food debris.
.
.
19