Star Progetti Heliosa 9/2S22BT Mode D'emploi page 27

5. START-UP
After installing the heater on the wall:
1. Press the main switch on the appliance.
A green light flashes for a few seconds to confirm the
operation.
2. Press the button on the device. *
The heater is equipped with 5 power settings. To adjust press the button stopping at the desired
power that will be displayed by the color of the LED. The power setting (MIN - 2 - MED - 4 -
MAX) takes place through a rotary cycle, ie repetitions of touches of the button.
The LED changes color
(Green, Yellow, Orange, Magenta, Red)
according to the set power level.
MIN - 2 - MED - 4 - MAX
* Alternatively, use the remote control.
Read the instructions on the following page
27