Care And Maintenance - Festo DNCM POT Série Notice D'utilisation

DNCM−...−POT
When using the DNCM−...−POT as a measuring cylinder:
Open up the one−way flow control valves until the desired speed is reached.
S
If set correctly, the work mass should reach the end position without striking
hard against it.
Conclude the test run.
S
8 Operation
Please note
S Make sure that nobody can place his/
her hand in the positioning range of the
moveable mass (e.g. by means of a pro
tective screen).
If the installation is properly protected,
it should not be possible to touch the
DNCM−...−POT until the work mass has
come to a complete stand.
S Make sure that no objects lie in or pro
ject into the positioning range of the
moveable mass.
9

Care and maintenance

Do not modify the settings of screws and threaded pins if there is no request to
S
do this in these operating instructions.
In this way you can prevent damage to your cylinder at a later stage.
Inspecting the DNCM−...−POT:
Send the DNCM−...−POT complete to Festo.
S
26
Fig. 16
Festo DNCM−...−POT 0608a English