Festo DNCM POT Série Notice D'utilisation page 20

DNCM−...−POT
Please observe the regulations applicable to the place of use and comply with
S
national and local regulations.
Remove the packing with the exception of the adhesive labels on the com
S
pressed air connections (to prevent dirt from entering) and on the cover of the
electrical connections.
The packaging is intended for recycling. (except for oiled paper which must be
disposed of ).
Take into account the prevailing ambient conditions.
S
Use the DNCM−...−POT in its original state. Unauthorized product modification
S
is not permitted.
6 Fitting
Fitting mechanical components
Check the application of the
S
DNCM−...−POT:
as a measuring cylinder,
with electronic closed−loop control.
Using the DNCM−...−POT with electronic
closed−loop control:
Use the DNCM−...−POT only in the ap
S
proved mounting positions. (see here
the drive−specific supplement for the
positioning controller type SPC−...
(Soft Stop)).
Check the following:
S
Do you require mounting accessories?
Are these mounting accessories suit
able for your application?
20
Fig. 4
Festo DNCM−...−POT 0608a English