Festo DNCM POT Série Notice D'utilisation page 21

DNCM−...−POT
In the case of direct fastening or use of
mounting accessories in each case with
cylinder collar hole milling:
Remove the coupling plate aA between
S
the connecting rod aF and the piston rod
aJ without stressing the connecting rod
(by counter force).
Torques and lateral forces on the connect
ing rod will damage the measuring sys
tem.
Place the mounting accessories on the
S
DNCM−...−POT and on the peripherals in
accordance with Fig. 6.
Make sure there is sufficient space for
S
tubing and connecting accessories.
In the case of direct fastening or use of
mounting accessories in each case with
cylinder collar hole milling:
fit the coupling plate again in accordance
S
with the section Dismantling and re
pairs."
When using the DNCM−...−POT with electronic
closed−loop control:
Please note
Special fitting conditions apply to the electronically closed−loop control of the
DNCM−...−POT:
S Observe the instructions in the manuals for positioning controller type SPC−...
(Soft Stop).
Place the DNCM−...−POT in the intended
S
position.
Screw fastening screws into the inner
S
threads of at least two collar screws 4.
Festo DNCM−...−POT 0608a English
Fig. 5
Fig. 6
Fig. 7
21