Adjusting The Handle; Information About Various Floorings; Trouble Shooting - WOLFF VARIO BRAVO-STRIPPER 013343 Mode D'emploi

09/2002 VARIO-STRIPPER , Artikel-Nr.

5.4 Adjusting the handle

The inclination of the handle can be adjusted to adapt the
machine to the stature of the operator. To adjust the inclination,
loosen the thumb screw at the foot of the handle.
After changing the inclination of the handle, it may be necessary
to readjust the handle attachment of the clutch. The clutch lever
at the motor housing must always be moveable to both end
positions.
If not:
r loosen the thumb screw (2) of the handle attachment of the
clutch
r
move the clutch attachment (3) up or down
5.5 Additional weight
The weight of the BRAVO-STRIPPER is as low as possible for
easy handling and transport.
To be able to work efficiently, the machine comes with an addi-
tional weight. Set the additional weight onto the front part of the
machine until it locks at the collateral bolt heads.

6.0 Information about various floorings

Main applications of the BRAVO-STRIPPER are carpets with
foam backing, CV-floorings, PVC-floorings and light carpets.
CV-floorings, PVC-floorings and carpets without foam backing
Cut stripes according to the blade width. Check from time to time
if the blade is straight.
Carpets with foam backing
Use sharp blades only. Remove upper layer with carpet clamp.
Remove the foam backing with the stripper. Remove foam
across the width if you have an uneven sub-floor.
Semi-flexible tiles
These tiles can be removed without pre-cutting, if they are not
bonded extremely tight.

7.0 Trouble Shooting

Trouble
Machine does not
run
Undue force necessary
or excessive vibration
Excessive vibration
013343Fu
Eventual cause
Power supply
disconnected
blown fuse
defective cable or plug
Blade is blunt
Expendable parts are
worn out
Elimination
Have machine
repaired by a qualified
electrician, respective
change parts
Change blade
Return machine for
service and/or repair
14