Setting The Speed - WOLFF VARIO BRAVO-STRIPPER 013343 Mode D'emploi

5.1 Hand clutch
The hand clutch is located in front of the handle of the machine.
Engage the motor drive by pushing the clutch forward / down.
By pulling the clutch upwards the BRAVO-STRIPPER stops.
Do not run the machine for a long while (e.g. during a break) with
the motor drive switched on and the clutch disengaged.
After changing the inclination of the handle, it may be necessary
to readjust the handle attachment of the clutch. See also
Chapter 5.4 "Adjusting the handle".

5.2 Setting the speed

To adapt the BRAVO-STRIPPER to different floorings, adjust the
speed. The optimum speed depends on the type of flooring, the
adhesive and the ambient temperature.
Therefore generally valid statements cannot be given.
If the blade jumps on top of the flooring, reduce the speed.
5.3 Setting the angle of the blade
The angle of the blade can be adjusted in 3 positions.
r remove screws (1) at both sides of the machine
r adjust the angle and tighten the screws in the
appropriate thread.
Optimum angle of the blade
The optimum angle of the blade depends on the type of flooring,
the adhesive and the subfloor.
Due to the variety of working conditions generally valid state-
ments cannot be given.
If the blade jumps on top of the flooring, set the angle steeper.
Set the angle flat with soft subfloors like particle boards or wood.
Otherwise you might deteriorate the subfloor.
09/2002 VARIO-STRIPPER , Artikel-Nr. 013343Fu
If the machine is switched on, but the hand clutch is not
engaged, it might happen that the machine runs slowly
"backwards". This is caused by the return stroke of the
blade action. It means no failure of the BRAVO-STRIPPER.
1
13