GiBiDi SL530 Instructions Pour L'installation page 14

14
UK
INTRODUCTION
The new 230Vac gearmotor SL530 allows easily and quickly automating small to medium-sized sliding gates of up to
500Kg.
WARNINGS FOR THE INSTALLER
• Before proceeding with installation, fit a magnetothermal and differential switch with a maximum capacity of 10A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3mm.
• All the packaging materials must be kept out of reach of children since they are potential sources of danger.
• The manufacturer declines all responsibility for proper functioning of the automated device if failing to use original
GIBIDI components and accessories suitable for the intended application.
• When installation has been completed, always carefully check proper functioning of the system and the devices
used.
• This instruction manual addresses persons qualified for installation of "live equipment", therefore, good technical
knowledge is required exercised as profession in compliance with the regulations in force.
• Maintenance must be performed by qualified personnel.
• Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
• This product has been designed and constructed solely for the use indicated in this document. Any other use may
cause damage to the product and be a source of danger.
• Verify the intended end use and take the necessary safety precautions.
• Use of the products for purposes different from the intended use has not been tested by the manufacturer and the
operations performed are therefore on full responsibility of the installer.
• Mark the automated device with visible warning plates.
• Warn the user that children and animals must not play or stand near the gate.
• Adequately protect the danger points, for example, using a sensitive edge.
• Check proper installation of the earthing system; connect all the metal parts of doors, gates, etc. and all the
system components equipped with earthing plate.
• Exclusively use original spare parts for any maintenance or repair.
• Do not make any modification to the components of the automated device unless expressly authorised by GIBIDI.
Use adequate cable clamps to ensure proper mechanical connection of the wiring and such that the IP55 degree of
protection of the box is maintained.
SL