Nakayama PRO PC4100 Mode D'emploi page 6

EN
1. When the ground is slippery or when other conditions exist which might make it not possible to maintain a steady posture.
2. At night ,at times of heavy fog ,or at any other times when you field of vision might be limited and it would be difficult to gain a clear view of the area.
3. During rain storms ,during lightning storms ,at times of strong or gale-force winds ,or at any other times when weather conditions might make it unsafe to
use this product.
e. When using this product for the first time ,before beginning actual work ,learn to handling it from skilled worker .
f. Lack of sleep ,tiredness,or physical exhaustion results in lower attention spans ,and this in turn leads to accidents and injury. Limit the amount of time of
using the machine continuously to somewhere around 10 minutes per session ,and take 10-20 minutes of rest between work sessions . Also try to keep the
total amount of work performed in a single day under 2 hours or less.
g. Be sure to keep this manual handy so that you may refer to it later whenever any questions arise .
h. Always be sure to include this manual when selling ,lending ,or otherwise transferring the ownership of this product .
i. Never allow children or anyone unable to fully understand the directions given in this manual to use this product.
Working Gear And Clothing
a. When using the product, you should wear proper clothing and protective equipment:
• Helmet
• Protection goggles or face protector
• Thick work gloves
• Non-slip sole work boots
• Ear protectors
b. And you should carry with you:
1. Attached tools and files.
2. Properly reserved fuel and chain oil.
3. Things to notify your working area (Rope, Warning signs).
4. Whistle (for collaboration or emergency).
5. Hatchet or saw (for removal of obstacles).
c. Never use the product when wearing pants with loose cuffs, when wearing sandals, or when barefoot.
Warnings considering handling of fuel
a. The engine of this product is designed to run on a mixed fuel which contains highly flammable gasoline. Never store cans of fuel or refill the fuel tank in
any place where there is a boiler, stove, wood fire, electrical sparks, welding sparks, or any other source of heat or fire which might ignite the fuel.
b. Smoking while operating the product or refilling its fuel tank is extremely dangerous. Always be sure to keep lit cigarettes away from the product at all
times.
c. When refilling the tank always turn off the engine first and take a careful look around to make sure that there are no sparks or open flames anywhere
nearby before refuelling.
d. If any fuel spillage occurs during refuelling, use a dry rag to wipe up spills before turning the engine back on again.
e. After refuelling, screw the fuel cap back tightly onto the fuel tank and then carry the product to a spot 3m or more away from where it was refuelled
before turning on the engine.
Before Starting Engine
Check working place, the cutting object and cutting direction. if there is obstacle, remove it. Never start cutting until you have a clear work area, secure foot-
ing and a planned retreat path from the falling tree.
Use caution and keep bystanders and animals out of the working area whose diameter is 2.5 times of cutting object.
Inspect the machine for worn, loose, or damaged parts. Never operate the machine that is damaged, improperly adjusted, or is not completely and securely
assembled. Make sure that the saw chain stops moving when the throttle control trigger is released.
When starting the engine
Always hold the machine firmly with both hands when the engine is running. Use a firm grip with thumb and fingers encircling the handles.
Keep all parts of your body away from the machine when the engine is running.
Before starting the engine ,make sure the saw chain is not contacting anything.
6
WWW.NIKOLAOUTOOLS.COM