FAFREES F26 Pro Manuel D'utilisation page 26

DISPLAY CONTROL PAD
1. Display interface switching：When the display is powered on, it will
show the Current Speed (km/h) and Trip Odometer (km) by default. Short
press the power button to switch between Trip Odometer(km), Odometer
(km), Maximum Speed (km/h), and Average Speed (km/h), etc.
2. Turn on the lights: By pressing and holding the plus button, the
controller will turn on/off the headlight.
3. Assist level: Use plus/minus button to switch the assist level. Power
assist is triggered when you pedal forward, and stops when you stop
pedaling, sometime with a delay.
4. Walk Assist Mode: Long press the minus button, the electric bicycle
will enter the walk assist mode. The electrical bike runs at a constant speed
of 6 km/h. Release the minus button, the electric bicycle will immediately
stop power output and return to the state before push.
ELECTRIC MODE
You do not need to pedal the e-bike if you use the hand throttle. The
throttle can be controlled by twisting it from the resting position, and the
farther the throttle switch is from resting position, the more power is sent to
the motor to accelerate the e-bike. The hand throttle can be removed if
you don't need it or due to local law restriction.
CRUISE CONTROL
Cruise control will be triggered when you holding thumb throttle and riding
at the same speed for 8 seconds, and it will be released by
braking/pedaling or throttling.
ERROR CODE
If there is a fault occurs in the electronic system of the electric bicycle, the
display will automatically show an error code, see below for a detailed
definition of the error code.
Error code Definition
E21 Current failure
E22 Throttle failure
E23 Motor phase failure
E24 Motor Hall failure
Error code
E25
E26
E30
EN 23
Definition
Brake failure
Low Voltage Warning
Communication failure