Stihl HTA 150.0 Notice D'emploi page 52

English
High limbing
► Hold the pole pruner with one hand by the
control handle – wrap your thumb around the
control handle.
► Hold the pole pruner firmly with your other
hand by the handle hose - wrap your thumb
around the handle hose.
12.5 Holding and controlling the pole
pruner (HTA 160.0)
► Connect the carrying ring (2) to the carabi‐
ner (1).
► Hold the pole pruner with one hand by the
control handle – wrap your thumb around the
control handle.
► Hold the pole pruner firmly with your other
hand by the handle hose - wrap your thumb
around the handle hose.
52
1
2
12.6 Limbing
Cross-cut
1
► Position the limit stop (1) against the branch.
The saw chain can be positioned precisely
using the gauge bar.
► With the chain running at full speed, press the
guide bar downward against the limb with a
leveraging movement.
► Cut through the limb with the bottom of the
guide bar.
2
► If the limb is under tension: Make the relieving
cut (1) into the compression side and then per‐
form the bucking cut (2) from the tension side.
Cutting thick branches
1
► Perform a relieving cut (2) at cutting point (2)
at a distance a = 20 cm from the final cross cut
(1).
► Perform a relieving cut and then a cross cut at
the desired cutting point (1).
For optimum performance, observe the recom‐
mended temperature ranges,
12 Using the Pole Pruner
1
a
2
20.7.
0458-038-9602-A