Stihl HTA 150.0 Notice D'emploi page 46

English
13
90°
c
► Align the housing (13) and transmission (3) as
shown.
► Tighten the screws (9) firmly.
The pole pruner does not need to dismantled
again.
8.2 Mounting the loop handle
(HTA 150.0)
► Switch off the pole pruner and remove the bat‐
tery.
1
2
6
7
► Fit clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Screw on and firmly tighten the nuts (7).
8.3 Attaching the clip (HTA 160.0)
► Switch off the pole pruner and remove the bat‐
tery.
2
► Press clip (1) together and place on the han‐
dle hose (2).
It is not necessary to remove the clip again.
46
3
90°
3
4
5
1
8 Assembling the Pole Pruner
8.4 Mounting the machine support
► Switch off the pole pruner and remove the bat‐
tery.
2
1
► Position the left half of the machine support (1)
against the side of the cover.
► Fit the screw (2).
► Position the right half of the machine sup‐
port (3) against the side of the cover.
► Fit the screw (5).
► Insert screws (4) and tighten.
► Tighten screw (2) and screw (5) firmly.
It is not necessary to remove the machine sup‐
port again.
8.5 Mounting the limit stop
(HTA 150.0)
3
2
► Position the limit stop (1).
► Fit the screw (2).
► Insert screw (3) through spiked bumper and
nut (4).
► Tighten down the screws (2) and (3) firmly.
8.6 Mounting and Removing the
Bar and Chain
8.6.1 Mounting the Guide Bar and Saw
Chain
The guide bar and saw chain combinations that
can be used with the chain sprocket are listed in
the specifications,
► Switch off the pole pruner and remove the bat‐
tery.
5
3
4
1
21.1.
0458-038-9602-A
4