Télécharger Imprimer la page

Stihl HTA 150.0 Notice D'emploi page 49

Publicité

Les langues disponibles
  • FR

Les langues disponibles

10 Switching Pole Pruning On and Off
► Press both locking levers (1).
The battery (2) is released and can be
removed.
10 Switching Pole Pruning On
and Off
10.1
Switching on the Pole Pruner
► Hold the pole pruner with one hand by the
control handle – wrap your thumb around the
control handle.
► Hold the pole pruner firmly with your other
hand by the handle hose - wrap your thumb
around the handle hose.
► Press the trigger lockout (1) with your hand
and keep it pressed.
► Push the release slide (2) in the direction of
the loop handle with your thumb and hold it
there.
LED is lit.
► Press the trigger (3) with your index finger and
keep depressed.
The motor is accelerated and the saw chain
rotates.
The more you depress the trigger (3), the faster
the saw chain rotates.
The pole pruner can also be switched on by first
pressing the release slide (2) and pressing the
trigger lockout (1) within 5 seconds (as long as
the LED is flashing). The trigger (3) is now
unlocked and the pole pruner is ready for use.
If the trigger (3) and the trigger lockout (1) are
released after switch-on, the LED flashes for
another 5 seconds. As long as the LED is flash‐
0458-038-9602-A
2
1
2
1
3
ing, the pole pruner can be switched on again
without having to actuate the release slide (2)
again.
10.2
Switching the Pole Pruner Off
► Release the trigger and trigger lockout.
► Wait until the saw chain comes to a complete
standstill after about 1 second.
► If the saw chain continues to run after about 1
second: Remove the battery and contact your
STIHL dealer for assistance.
The pole pruner has a malfunction.
11 Checking Pole Pruner and
Battery
11.1
Checking the Chain Sprocket
► Switch off the pole pruner and remove the bat‐
tery.
► Remove the chain sprocket cover.
► Remove the guide bar and saw chain.
a
► Use a STIHL gauge to check the wear marks
on the chain sprocket.
► If the wear marks are deeper than a = 0.5 mm:
Do not use your pole pruner and contact your
STIHL dealer for assistance.
The chain sprocket must be replaced.
11.2
Checking the Guide Bar
► Switch off the pole pruner and remove the bat‐
tery.
► Remove the saw chain and guide bar.
► Measure the depth of the guide bar with the
scale on a STIHL filing gauge.
English
49

Publicité

loading

Ce manuel est également adapté pour:

Hta 160.0