Ghibli & Wirbel Power Indust AX20 Z22 Utilisation Et Entretien page 61

5.5 Troubleshooting
Fault found
The cleaner fails to start
Dust is leaking out
The vacuum cleaner does not work as it
should
Motor very noisy.
Warning!
For any other problems, contact the GHIBLI&WIRBEL after-sales service.
Possible fault
No power
Thermal magnetic switch
tripped
Perforated vacuum pipe
Filter unsuitable for type of job
Pipe perforated or blocked
Container full
Filter blocked
Seals worn
Air leak
Contact GHIBLI&WIRBEL after-sales
ENGLISH - 30 -
Recommended remedy
Check the power mains
supply
Check the integrity of the
plug and power cable
Reset the thermal magnetic
switch
Replace the pipe
Fit a suitable filter for the
type of material to be
vacuumed
Check the pipe and, if
necessary, replace it
Empty container
Clean the filter and if
necessary change it.
Check the seals and, if
necessary, replace it
Check for any air leaks out of
closing fasteners, tightening
screws, container or filter
chamber