Publicité
Les langues disponibles
Les langues disponibles
TRANSPORT AND HANDLING
During transportation, hold the base and lift the
refrigerator carefully with an angle inferior than 45
degrees. Never hold the door handle as a support. Never
place it upside down nor horizontally. Push refrigerator
on its basis and place it with the help of its roller feet.
INSTALLATION AND OPERATING CONDITIONS
This refrigeration appliance is intended for use as a built-in
appliance.
• Installation before using the appliance for the first time
1. Take the product out of the package, remove the scotch
tape protecting the door and the equipment. Any remaining
adhesive stains may be removed with a mild washing agent.
2. Do not throw away the polystyrene elements of the
packaging. If it is necessary to transport the appliances, pack
it in the polystyrene elements and film as well as protecting it
with scotch tape
3. Clean the interior surface of the appliances and the
elements of the equipment with a washing agent dissolved in
lukewarm water, then wipe it dry.
• Ventilation (Figure 1)
1. Level the kitchen cabinet with a level and a square. If
necessary, add shims in the base.
2. Keep a minimum distance of 38mm behind the
appliances for ventilation.
3. The air intake A must be at least 200 cm² and the air must
enter the base of the cabinet through the panel.
4. Check that the position of the socket (1) is correct. The AC
voltage at the point where the appliance will be used must
comply with the data on the nameplate affixed to the inside
left wall of the appliance, near the vegetable box. The outlet
must be properly grounded.
- 7 -
Publicité
