During Operation - Conrad Reely Mini Wavebreaker Notice D'emploi

• Always switch on the transmitter first. Then the drive battery of the model may be connected.
If you proceed in any other order, there may be unforeseeable reactions of the receiver system in the model and the
ship's propellers may start up unplanned! There is a danger of accident and injury!
• Before any commissioning, check for correct and tight fit of the ship's propellers and for any damage to them.
• When the ship propellers are running, make sure that neither objects nor body parts are in their rotating and suction
area.
d) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends completely
on your responsible use of the model.
• Improper operation can cause serious damage to people and property! Therefore, make sure that there is a suffici-
ent safety distance to any persons, animals or objects in operation.
• Select suitable body of water to operate your model. In doubt, ask the person responsible for the body of water
whether operation of your model is permitted there.
• The selected body of water must be free of climbers (e.g. seaweed) for operation of your model. There also must be
no objects (e.g. branches) floating in the water.
• Observe currents and other detriment conditions in the selected body of water that may make operation of the model
difficult or even impossible. Danger of loss of the model!
• Drive your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• Never drive right towards any swimming persons or animals.
• Never point the aerial of the transmitter onto the model. Because of the principle this will reduce the range between
the transmitter and the model. The best range will be reached if the aerial of the transmitter points vertically up
(aerial of the transmitter is parallel to the aerial of the model).
• Motor, speed controller and drive battery may heat up during operation of the model. For this reason, wait for 5 to
10 minutes before recharging or replacing the drive battery. The drive motors must have cooled down to ambient
temperature.
• Never switch off the remote control (transmitter) while the model is in use. After a voyage, always disconnect the
drive battery first or switch off the model. Only then must be remote control be switched off.
• In case of defect or malfunction, remove the cause of the interference before starting your model again.
• Never expose your model and the remote control system to direct solar irradiation or great heat for an extended
period.
27