Range Test; The First Trip - Conrad Reely Mini Wavebreaker Notice D'emploi

Curves are controlled by switching one motor on or off. If, for example, you want to initiate a curve to the left, while
driving your model forward, the left motor will be switched off. The right motor continues to run.
Check the function „driving to the left". The drive lever remains in the neutral position for this function test. Push the
control lever of the transmitter (figure 5, item 4) to the left. Now the right ship's propeller has to turn.
Check the function „driving to the right". The drive lever remains in the neutral position for this function test. Push the
control lever of the transmitter (figure 5, item 4) to the right. Now the left ship's propeller has to turn.
d) Range Test
Before first use, the drive battery and any rechargeable battery used in the transmitter have to be charged as instruc-
ted by the manufacturer.
For reasons of operating safety, we recommend only using a battery, not a rechargeable battery, in the
transmitter.
Perform a range test of the remote control system. For this, take the transmitter and then the ship's model not operati-
on by connecting the drive battery. Now check the range of your remote control with a helper, by having the helper hold
the operational model ship in the water and you moving away from the model. Control must work interference-free at
least at a distance of 30 metres.
e) The First Trip
The ship's model must only be driven with the canopy attached and locked. Otherwise, splashing water may
enter the boat and destroy the remote control and drive parts. Loss of guarantee/warranty!
The model's control electronics have no undervoltage recognition for the drive battery integrated for safety-
technical reasons. If the battery switches off to prevent harmful deep discharge of the drive battery, the
model would float and be no longer controllable, and might be lost. Therefore, interrupt operation in time
(but no later than after 8 to 10 minutes) to reach the shore under own power and to avoid deep discharge of
the drive battery.
Trips under detriment conditions such as strong wind and strong waves are not permissible and may cause
loss of the model.
If you notice any unusual noise or sudden rotating or model speed loss during operation, terminate operation
at once and find the reason. In most cases, seaweed or something similar will have become tangled in the
ship's propellers and/or drive shafts, which may impair or render the drive near ineffective. If operation is
continued, this may destroy drive components. Loss of guarantee/warranty!
Carefully and horizontally put the model on the water. Observe that the ship's propellers have no ground contact and
can turn freely.
Never touch the model in the area of the ship's propellers. Inadvertent start-up of the ship's propellers will
cause severe injury otherwise!
35