SICK G20 Notice D'instructions page 37

6 Commissioning
6.1 Alignment
6.2 Check the application conditions
8026844.1K1V/2024-02-08 | SICK
Subject to change without notice
3 A @ 250 V AC, resistive (NC)
4 A @ 24 V DC, NO, general use
3 A @ 24 V DC, NC, general use
R300/B300 (NO contacts only)
NOTE
In the UL statement, the terms "NO and "NC" are used to denote the status of the relay
switch when the sensor is not powered on.
Align the sensor with a suitable reflector. Select the position so that the red emitted
light beam hits the center of the reflector. The sensor must have a clear view of the
reflector. There must be no object in the path of the beam [see
ensure that the optical openings of the sensor and reflector are completely clean and
not covered.
Figure 3: Alignment
Adjust the distance between the sensor and the reflector according to the correspond‐
ing diagram [figure 4] (x = sensing range, y = operating reserve).
OPERATING INSTRUCTIONS
figure 3]. You must
O P E R A T I N G I N S T R U C T I O N S | GLD20
en
37