Publicité
Les langues disponibles
Les langues disponibles
Preparing the Engine
1. While the engine is still warm, change the engine oil;
refer to Changing the Engine Oil (page 16).
2. Remove the spark plug.
3. Using an oil can, add about 1 oz (30 ml), of motor oil
to the engine through the spark-plug hole.
4. Slowly pull the starter rope several times to distribute
oil throughout the cylinder.
5. Install the spark plug but do not connect the wire to
the spark plug. Secure the wire so that it does not come
into contact with the spark plug.
Removing the Machine from
Storage
1. Unfold the handle; refer to
Adjusting the Handle Height (page 10).
2. Check and tighten all fasteners.
3. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
4. Inspect the spark plug and replace it if it is dirty, worn,
or cracked; refer to the engine operator's manual.
5. Install the spark plug and tighten it to the recommended
torque of 180 in-lb (20 N-m).
6. Perform any needed maintenance procedures; refer to
Maintenance (page 15).
7. Check the engine oil level; refer to
Checking the Engine Oil Level (page 9).
8. Fill the fuel in the fuel tank with fresh gasoline; refer to
Filling the Fuel Tank (page 8).
9. Charge the battery (electric-start model only); refer to
Charging the Battery (page 17).
10. Connect the wire to the spark plug.
24
Publicité
