Publicité
Les langues disponibles
Les langues disponibles
1/ DESCRIPTION OF YOUR WINE CABINET
A
B
C
D
E
F
G
H
I
J
A
Cabinet body
B
Lighting (light strip and 2 LEDs)
C
Breather hole and charcoal filter
D
Storage shelf
E
Filler strip (x2)
F
Main du Sommelier support (MDS)
G
Power lead – 2 metres
H
Wine service area
I
Rack, humidity cartridge (Single temperature
model only)
J
Lower strip – air outlet
K
6
Upper strip – air inlet
GB
K
L
M
N
O
P
Q
R
S
T
V
W
L
Upper hinge
M
Setting and controlpanel
N
Door stop
O
Magnetic door seal
P
Sliding shelf
Q
Lock (Full glass and glass with stainless steel
doors only)
R
Door
S
Half shelf
T
Product identification label
V
Lower hinge
W
4 adjustable feet
2/ POWER SUPPLY
The wine cabinet's power lead has a plug, to be plugged into a standard earthed outlet to prevent
any risk of electric shock.
Visit your usual EuroCave stockist to change the power lead if it is damaged. It must be replaced by
a EuroCave genuine manufacturer's part.
3/ PROTECTING THE ENVIRONMENT
ECODESIGN
Spare parts for our appliances are available for 11 years.
For further
information, contact your EuroCave stockist. For France, contact our
customer service department. Contact details at www.eurocave.com
Disposing of packaging
The packaging used by EuroCave is made from recyclable
material (except for the two wedges in high density
expanded polystyrene and the cabinet's protective plastic
in low density polyethylene). After unpacking your cabinet,
take the packaging to a refuse collection point. For the
most part, it will be recycled.
Recycling: a caring gesture
Electrical and electronic equipment is potentially harmful to the
environment and human health owing to the presence of hazardous
substances. Therefore, you should never dispose of electrical or electronic
equipment waste with unsorted municipal waste. When you buy a new
4/ INSTALLING YOUR WINE CABINET
Unpacking
When your cabinet is delivered, check the outside for signs of damage
•
(impact, warping...).
Open the door and check that the elements inside your appliance are
•
intact (walls, Main du Sommelier supports, hinges...).
Remove the protective components inside your cabinet.
•
Unscrew the filler strips located at the back of the cabinet body. (see
•
below)
Remove the 4 screws of the two protective plates using an Allen key (not
•
supplied) and replace with the two aesthetic plates, fastened by the 4 black
M5 countersunk screws.
(We recommend that you retain the protective plates you removed in case
you need to transport your cabinet in the future).
2
1
5
6
7
4
3
5
6
4
7
N.B.: the power lead's plug must be accessible to allow the appliance to be
disconnected from the electricity mains after installation.
Have the power supply socket checked by a qualified electrician who will confirm if it is
correctly earthed or will carry out, if necessary, work to make it compliant.
If moving to a foreign country, check whether or not the supply characteristics of the
cabinet correspond to the country (voltage, frequency).
EuroCave product, you can entrust the recycling of your old appliance to
your EuroCave stockist. Contact your EuroCave stockist, he will explain
the removal and collection procedures in place within the EuroCave
network.
In compliance with legislation on protecting the environment, your wine
cabinet does not contain C.F.C.s or H.C.F.C.s.
To save energy
Install your cabinet in a suitable place (see next page) and observe the
•
temperature ranges provided.
Keep the door open for as short a time as possible.
•
Ensure that the door seal is in good condition and is not damaged. If it
•
is, contact your EuroCave stockist.
We recommend that you fill your wine cabinet to at least 75% of its
•
total capacity.
Disable unusable appliances by unplugging them and removing the power
lead.
• Protective wedges for transportation have been attached to each shelf. 2
wedges per shelf (Picture 1). Remove all of them using a rotating movement
(Picture 2). You can retain these wedges and reuse them if you have to
transport your wine cabinet over a long distance.
Precautions
View 2
View 1
Do not place your cabinet in an area likely to flood.
•
Do not expose your cabinet to direct sunlight.
•
Ensure that the entire back and top of the appliance are not subject to
•
splashes of water.
In order to secure your cabinet, full glass and glass with stainless steel
•
doors
have a lock.
Unwind the power lead so that it is accessible and does not come into
•
contact with any of the appliance's components.
7
GB
Publicité
