Publicité
Les langues disponibles
Les langues disponibles
6/ USING YOUR WINE CABINET FOR THE FIRST TIME
1. Connection and starting up
Wait 48 hours before plugging in your wine cabinet.
By default, the control is in the OFF position. To switch on the cabinet,
•
press and hold the
button for several seconds until just the temperature
is displayed.
To put the cabinet on standby, press and hold down the
•
several seconds. The display switches between the internal temperature
and the OFF display (the cabinet is no longer operating, only the display is
active).
II. Description
1
2
3
III. Temperature setting
The temperature of your wine cabinet is set exclusively from the control
panel.
1
Press and hold down the SET key for a few seconds until the set
temperature (ST1) flashes.
The default temperature setting is 12°C (ideal wine maturing
temperature). However, the temperature can be set from 9°C - 15°C.
The recommended setting range for storage is 10°C - 14°C.
5 sec.
2
Set the desired temperature using the
and
.
12
GB
•
To reactivate the cabinet back on, press and hold down the
for several seconds until just the temperature is displayed.
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker). Fuse of 10A for one unit, 15A for two and 25A
for three.
Use of multi-socket plugs is not recommended if it does not respect
button for
above electrical data as well
Do not plug several cabinet into a multi-socket.
1
Compressor: indicates that the compressor is in operation. When
it flashes, it means that the compressor is going to start in the next
few minutes (time required to perform action).
2
Heater: indicates that the heater is in operation.
3
Alarm: indicates an abnormally high or low temperature inside the
wine cabinet.
3
Confirm your programming by pressing the SET button. If you do not
confirm your setting using this key, your modification will not be taken
into account.
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
Alarms
If the temperature inside the cabinet is 6°C above or below the
temperature setting, for over 18 hrs, the control activates the
visual and audible alarm: the
warning light appears. Press the
SET button to stop the alarm.
NB : If you have loaded your cabinet with a large number of bottles, it
can take several days for your wine cabinet's temperature to stabilise. The
alarm may then sound and the
warning light may then appear. Wait a
while then check again. If the alarm still sound and the alarm warning light
does not disappear, contact your retailer.
Warning: to function correctly, your cabinet must be placed in a room
with a temperature of 0 - 35 °C / 32 - 95°F.
button
Your EuroCave cabinet is a tried and tested appliance.
Maintenance operations to be carried out approximately once a
year
•
Unplug and unload the appliance.
•
Clean the water drain at the bottom of the wine cabinet. Pay attention that nothing is blocking this
drain.
•
Regularly vacuum the condenser at the back of the appliance.
•
Clean the inside of the compartments with water and a gentle cleaning product.
•
Rinse thoroughly.
•
Dry it with a soft rag.
•
Replace the active charcoal filter in the breather hole at the top of your cabinet
•
Remove the charcoal filter manually. It is available from your usual retailer. It must be replaced by
an original manufacturer's part.
•
Check that the seals are in good condition. It is often necessary to clean the door seal. Using
unsuitable cleaning products can cause premature ageing of the seals. Certain rules must therefore
be followed: whenever you clean the seal, always rinse off any cleaning product with clear water. All
traces of cleaning product must be removed from the seal. EuroCave only recommends using a mild
soapy solution. If this proves insufficient, it is possible to occasionally use an ethanol-based solution,
provided that the concentration used is less than 10% and that the seal is then rinsed thoroughly with
clear water.
Caring for glass elements:
To clean the glass elements of your cabinet, use a non-abrasive soft cloth which has had a suitable glass cleaning product applied to it.
•
When starting up
•
The compressor does not work > ensure that the wall socket is correctly supplied with power by plugging in another electrical appliance.
5 sec.
•
The compressor never stops > put your hand on the condenser (grille located at the back of the appliance). If the condenser is cold, contact your
retailer. If the condenser is warm, set the temperature (ST1) of your wine cabinet to 15°C, the maximum value in the setting range. If the compressor still
does not stop, contact your retailer.
•
The wine cabinet does not switch on > contact your dealer/EuroCave after-sales service.
ANY WORK CARRIED OUT BY TECHNICAL SERVICES
NOT APPROVED BY EUROCAVE SHALL RENDER THE
WARRANTY NULL AND VOID.
If your appliance does not seem to be working correctly, contact your EuroCave retailer.
Minimum duration of guarantee offered by the manufacturer: 2 years parts.
7/ EVERYDAY MAINTENANCE
8/ OPERATING FAULTS
The use of glass doors can alter your wine cabinet's performance
in some extreme temperature conditions.
13
GB
Publicité
