Publicité
Les langues disponibles
Les langues disponibles
Checking controller:
• Check the thin rubber gaiter or boot around the base of the
joystick shaft for damage or splitting. Check visually only, do
not handle the gaiter.
• Make sure that all components of the control system are
securely mounted. Do not over-tighten any securing screws.
Please refer to Service manual for any information about
Torques & Service manual
Checking controls:
• Switch on the hand control – Do the lights flash? This
signifies that there is a fault in the electronic system. Refer
to chapter 9 for basic troubleshooting
• Operate all of the electric options, including lights and
indicators, (if fitted), to make sure that they work correctly.
• With the seating in an elevated position, drive the
wheelchair to make sure that the 'creep' mode works which
will slow the wheelchair.
• Drive the wheelchair in each of the drive profiles to make
sure the wheelchair performs as it did before.
Q700 M Rev.1.0
All manuals and user guides at all-guides.com
• If you are in any doubt about the performance
• After performing any maintenance or repairs on the
• A complete inspection, safety check and service should be
• All fasteners must be replaced like for like using the correct
• When replacing self-locking nuts, or nuts/studs secured
• Check all Velcro fastening straps for correct adhesion when
• Ensure that any contamination, such as fluff, hair,etc is
Monthly checks
Perform the monthly check routine before driving as described
below.
• All fasteners should be checked monthly for wear, such as
• Check all straps monthly for fraying, ripped seams or other
WARNING!
requirements of your wheelchair contact your Sunrise
Medical authorised dealer.
wheelchair you must make sure that it is functioning
correctly before it is used.
made by a Sunrise Medical authorised dealer at least once
per year.
length, tensile strength and materials.
with a thread locking solution, ensure that a suitable thread
locking solution is reapplied to the fastener.
pressed together.
removed from the Velcro straps. Such contamination may
affect adhesion.
loose bolts or broken components.
indications of excessive wear damage. Discontinue use if
damage is found.
31
Publicité
