Dust Extraction; Working With The Machine - Festool KA 65 Guide D'utilisation

Remove the edge band
An edge band was detected when
the machine was switched on.
Request for removal of the edge
band. Press the start button [1-1]
and hold until the edge band has
passed through.
Purging position reached
2
190 °C
Central plate [1-12] has been
lowered completely and moved to
MODE
purging position.
Purging process starts
Start button [1-1] was pressed.
The purging process starts after
one second.
Purging process is carried out
2
190 °C
Adhesive nozzles are open, pres-
sure has built in the adhesive car-
tridges. Display of the current
status.
Cooling mode
180 °C
The machine reduces the tem-
perature in cooling mode and
then switches off. Cooling mode
is activated when:
– on/off switch [1-8] is pressed <
1 s
– no controls are actuated for
more than 15 minutes
The machine is switched on again
by pressing the start button [1-1]
or the on/off switch [1-8].
WARNING
High temperatures on the heating unit and adhe-
sive nozzle!
Risk of burns when touched
Wear suitable protective gloves.

Always hold the machine by the insulated han-

dles [1-3], [1-16]!
0
**
Automatic calculation of currently detected edge
height
Vapours emitted during the glueing process!
Ensure there is good ventilation.

Use an extractor.

Always observe national regulations.

An extractor hose with a diameter of 27 mm can be
attached to the extractor connector [1-6].

Working with the machine

Moving workpiece!
Risk of injury from sliding workpiece
Always secure the workpiece in such a manner

that it cannot move.
Fault symbol
Troubleshooting (chapter ).

Dust extraction

CAUTION
WARNING
13