Menu Buttons - Festool KA 65 Guide D'utilisation

Selecting the feed speed
The feed speed can be adjusted and adapted to the
contour of the workpiece at any time by pressing
the button [1-2].
1st gear = 2 m/min
2nd gear = 4 m/min

Menu buttons [1-19]

The following settings can be modified using the
menu buttons [1-19]:
– Adhesive quantity
– Setpoint temperature
– Units of measurement
If no menu buttons are pressed within 10
seconds, the menu is closed automatically
and the changes are discarded.
Mode button
MODE
Press the button to select the
value you wish to change
(flashes).
Arrow buttons
The selected value can be
adjusted.
OK
OK
Press <OK> to save any changes.
Display [1-20]
The current settings and information graphics are
shown on the display [1-20].
Temperature selection [1-7]
1 2
Setting 1 (190 °C) / Setting 2 (200
°C)
Feed speed[1-2]
1st gear (2 m/min) / 2nd gear (4
m/min)
Units of measurement
°C/m, °C/ft, °F/ft, °F/m
Select from °C/m, °C/ft, °F/ft or
°F/m.
°C = degrees Celsius
m = metres
°F = degrees Fahrenheit
ft = feet
12
Remaining edge length
33,0 m
Edge band length in relation to
the remaining quantity of adhe-
sive.
Adhesive quantity
Setting for the required adhesive
quantity.
Actual and setpoint temperature
130 190 °C
Display [1-20] lights up red
during heating mode.
Setpoint temperature
190 °C
Ready for operation, display [1-
20] lights up green.
Refill button [1-21]pressed
Adhesive feed is reversed for refill
process.
Open flap [1-18]
Adhesive feed was reversed for
refill process. Flap [1-18] can be
opened.
Insert adhesive cartridges
The magazine can be refilled with
adhesive cartridges.
Close the flap [1-18]
Work can continue after the flap
[1-18] is closed.
Refill process complete
Adhesive feed moves forward and
pressure builds in the adhesive
cartridges.
Edge inlet ready
Guide the edge band into the
edge inlet [1-11] within 20 sec-
onds. The remaining time is dis-
played. If the edge band is not
inserted within the specified time,
the start button [1-1] must be
pressed again.
Edge band to start position
Now press the start button
[1-1] to glue the edge band. The
inlet starts up and transports the
edge band through the machine.
**