Festool KA 65 Guide D'utilisation page 15

Refilling an adhesive cartridge [6]
6-2
6-1
6-3
Press the refill button [6-1].

Adhesive feed [6-2] moves back.
Open the flap [6-3].

Insert adhesive cartridges in the magazine.

Close the flap [6-3].

Wait until the adhesive feed [6-2] mechanism

has moved forward and pressure has built up in
the adhesive cartridges.
The refill process is complete, machine operation
can resume.
Purging of adhesive cartridges
WARNING
Adhesive may escape immediately after actuat-
ing the safety lever [1-8] and simultaneously low-
ering the central plate [1-12] (purging position)!
Risk of burns, damage to property from hot adhe-
sive
Remove the drop catcher and place a larger con-

tainer such as a cardboard box under the ma-
chine.
– The colour of adhesive cartridges is changed
– Changing from EVA to PU adhesive
– Purging PU adhesive from the machine using
cleaning cartridges
Approximately three adhesive cartridge are
required to purge the machine completely.
If necessary, press the refill button [1-21] for
other adhesive cartridges and repeat the
procedure.
7
Position the machine at the edge of the bench

[7].
Remove the drop catcher [1-13].

Place the container for catching hot adhesive

into position.
Press the refill button [1-21].

Adhesive feed moves back.
Open the flap [1-18].

Remove all the adhesive cartridges.

Insert new adhesive cartridges.

Close the flap [1-18].

Set the edge height to maximum using the rota-

ry knob for adjusting the edge height [1-4].
Actuate the safety lever for purging the machine

[1-9] while simultaneously turning the rotary
knob for adjusting the edge height [1-4] clock-
15