Publicité
Les langues disponibles
Les langues disponibles
7.3 Integration of conventional operating elements
With V.1.04 it is possible to integrate conventional operating elements into your sauna system. These then dis-
play the operating mode selected by you. You can make or change settings on the operating element - the ope-
rating elements communicate with your wave.com4 touch operating elements.
Operating elements which can be used:
WC4-B-S/W/D/H
In order to use this function with the WC4-SL-S/W/H/D operating element, if produced prior to 11/2012
your operating element may require a software update. It is necessary to send in the WC4-SL-S/W/H/D
operating element for this purpose.
Before connecting the WC4-SL-S/W/D/H operating element, the operating element must have been
previously configured to BUS configuration. Proceed as follows here:
*
Unplug operating element from power element (RJ10 4/4).
*
Keep +/- buttons depressed simultaneously and plug the RJ10 4/4 data cable in again.
*
Select 'TC4' with the +/- buttons.
*
Confirm the selection with the Mode button.
*
Select 'Po0' with the +/- buttons.
*
Confirm the selection with the Mode button.
The conventional operating elements WC4-B-S/W/D/H, WC4-IRX-S/W/D/H, WC4-SL-S/W/H/D can be
installed within your sauna cabin. Please observe the comments in the respective operating instructions to
this end. The environmental parameters (see Technical Data of the respective operating instructions) must
be complied with under all circumstances.
When 2 operating elements are used on the bus (possible for Wave.com4 and Wave.com4 Infra- RJ10 4/4
connection and also S&L) it must be considered that each individual operating element is assigned to a different
bus address in each instance. To this end, observe further comments in the respective operating instructions
(Wave.com4 and Wave.com4 Infra)
WORLD OF WELLNESS
Instructions for installation and use – only for experts
WC4-IRX-S/W/D/H
WC4-SL-S/W/H/D
P. 10/22
Publicité
