Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
The model number, power supply and connected load are specified on
the data plate.
The data plate is attached to the base of the appliance.
The connection cable is of the type Y.
This means that the connection cable may only be replaced by the
manufacturer, the service organisation or similarly qualified persons, in
order to prevent dangerous situations.
Refer to the figure below for the wiring diagram, which can also be
found on the underside of the appliance.
If you want to make a fixed connection, make sure that a multi-polar
switch with a contact separation of at least 3 mm is fitted in the supply
line.
130
electrical connection
negative connection N1 (blue)
positive connection L1 ( grey)
INSTALLATION
A view of the power cable is shown schematic below:
L1,
grey
L2,
black
2 phase connection
2 positive + 2 negative 2 2N a.c. 230 V
The fuse box in your home must be fitted with a 16 A fuse.
negative connection N2
blue
(brown)
brown
positive connection L2
(black)
N1
N2
L1
230V
230V
2 fase + 1 nul
2 2N a.c. 400 V
The fuse box in your home must be fitted with a 16 A fuse.
negative connection N
blue
(blue and brown)
positive connection L1
brown
(grey)
positive connection L2
(black)
N
L1
230V
230V
Do not connect the 3rd phase.
electrical connection
ground
yellow/green
N1,
blue
N2,
brown
grey
black
yellow/green
L2
grey
black
yellow/green
L2
131
Publicité
